Industry News

What are the steps in the production and processing of stainless steel precision hardware accessories?


What are the steps in the production and processing of stainless steel precision hardware accessories? Employees check their clothing before entering the workplace. Slippers, high-heeled shoes and clothing that affect safety are not allowed, and those with long hair must wear a helmet. Maintain the correct posture when working, have sufficient energy to cope with the work, and immediately leave the work post if you find that you are unwell, and report to the leader. When operating, it is necessary to concentrate on thinking, and it is strictly forbidden to chat and cooperate with each other. The operator cannot operate in a state of irritability and fatigue, so as to avoid accidents and ensure safe operation.

Before working, check whether the moving parts are filled with lubricating oil, then start and check whether the clutch and brake are normal, and run the machine tool for 1-3 minutes. When replacing the mold, turn off the power first, and then start to install and debug the mold after the movement of the punch press stops.

After installation and adjustment, move the flywheel by hand to test punch twice to check whether the upper and lower molds are symmetrical and reasonable, whether the screws are firm, and whether the blank holder is in a reasonable position. You must wait for all other personnel to leave the mechanical work area and remove the sundries on the workbench before starting the power supply to start the machine.

After the machine is started, one person shall transport the materials and operate the machine. Others shall not press the electric construction or step on the foot switch, let alone put their hands into the working area of the machine or touch the moving parts of the machine with their hands. When the machine is working, it is forbidden to put your hand into the working area of the slider, and it is strictly forbidden to take and place the workpiece by hand. Standard tools must be used when picking and placing workpieces in the die. If you find that the machine has abnormal sound or the machine fails, you should immediately turn off the power switch for inspection.

When leaving get off work, the power supply should be turned off, and the finished products, scraps and sundries on the post should be sorted out to ensure a clean and safe working environment. The above operating rules must be consciously abide by, do not operate in violation of regulations, if a fault occurs, you should cooperate with maintenance personnel to overhaul, immediately cut off the power supply in case of an accident, keep on-site report to the factory and wait for processing, all consequences caused by violation of the operating rules, the parties shall bear all the consequences.