Industry News

What are the process conditions of PBT injection molding?

Forming and processing properties of PBT

1) The moisture absorption of PBT is small, but it is sensitive to moisture at high temperature. During molding, PBT molecules will be degraded, the color will become darker, and the surface will produce

Mark, so it should be dried normally.

2) PBT molten material has excellent fluidity, so it is easy to form thin-walled and complex shaped products, but pay attention to mold overflow and nozzle salivation

Phenomenon.

3) PBT has an obvious melting point. When the temperature rises above the melting point, the liquidity will increase sharply, which should be noted.

4) PBT molding processing range is narrow, cooling crystallization is fast, coupled with good liquidity, especially suitable for rapid injection.

5) PBT has a large shrinkage rate and its shrinkage range, and the difference of shrinkage rate in different directions is more obvious than other plastics.

6) PBT is very sensitive to notch and sharp corner. Stress concentration is easy to occur at these positions, which greatly reduces the bearing capacity

It is easy to crack when striking, so attention should be paid to this point when designing plastic parts. All corners, especially internal corners, should be rounded as far as possible

Du.

7) The elongation of pure PBT can reach 200%, so the products with small depressions can be forced to demould from the mold. But filled with glass fiber or filler

After that, its elongation is greatly reduced, and forced demoulding cannot be carried out in case of any depression in the products.

8) When possible, the runner of PBT mold should be short and thick, and the round runner is the best- Ordinary modified and unmodified PBT can be used

However, glass fiber reinforced PBT can only have a good effect by hot runner molding.

9) The shearing effect of the point gate and the latent gate is large, which can reduce the apparent viscosity of the PBT melt, and is conducive to forming. They are frequently used gates

The mouth diameter should be larger.

10) It is better to face the core cavity or core directly with the gate, so as to avoid spraying and minimize the back filling when the molten material flows in the cavity. Otherwise, the product capacity

It is easy to produce surface defects and degrade the performance.

Contact Us

Inquiry For Pricelist

For inquiries about our products or pricelist, please leave your email to us and we will be in touch within 24 hours.

Latest News